BIOS Setup Program
107
Table 74. Boot Menu (continued)
Feature Options Description
1
st
Boot Device
2
nd
Boot Device
3
rd
Boot Device
4
th
Boot Device
5
th
Boot Device
• Floppy
• ARMD-FDD
(Note
1
)
• ARMD-HDD
(Note
2
)
• IDE-HDD
(Note
3
)
• ATAPI CDROM
• Intel UNDI,
PXE 2.0
(Note
4
)
• Disabled
Specifies the boot sequence according to the device
type. The computer will attempt to boot from up to five
devices as specified here. Only one of the devices can
be an IDE hard disk drive. To specify boot sequence:
1. Select the boot device with <↑> or <↓>.
2. Press <Enter> to set the selection as the intended
boot device.
The default settings for the first through fifth boot
devices are, respectively:
• Floppy
• IDE-HDD
• ATAPI CDROM
• Intel UNDI, PXE 2.0
• Disabled
NOTE: To configure the computer to boot from an IDE
hard disk drive, set a boot device in the Setup feature to
IDE-HDD
. Determine the IDE channel, and master or
slave mode of the drive. Then, in the next Setup
feature,
IDE Drive Configuration
, set that channel and
mode to
1
st
IDE
.
4IDE Drive Configuration
Primary Master IDE
Primary Slave IDE
Secondary Master IDE
Secondary Slave IDE
• 1
st
IDE (default)
• 2
nd
IDE
• 3
rd
IDE
• 4
th
IDE
1
st
IDE
specifies the IDE hard disk drive to boot from.
The
2
nd
through
4
th
IDE
settings are ignored. See the
note above for more information.
To specify the drive to boot from:
1. Use <↑> or <↓> to select the channel, and master
or slave mode of the drive to boot from.
2. Press <Enter>.
3. Use <↑> or <↓> to select 1
st
IDE.
4. Press <Enter> to set the selection.
Notes:
1 ARMD-FDD = ATAPI removable device - floppy disk drive
2 ARMD-HDD = ATAPI removable device - hard disk drive
3 HDD = Hard disk drive
4 This boot device is available only when the onboard LAN subsystem is present.
To Next Page
Loading...
Need help?
General
