Windows NT Installation 3-5
15 The country identifier utility will be autmatically launched. At the
country identifier utility screen, make the appropriate country
selection.
16 At the Install New Modem screen click Finish.
17 At the Modems Properties screen click Dialing Properties... to set
up dialing properties (not necessary if a modem had been previously
installed). Click Close.
Windows NT 3.51 Installation
PCMCIA Services Verification
Before installing the Intel adapter, make sure that PCMCIA services are
enabled on your computer.
1 Select Devices from the Control Panel.
2 Scroll down the Device list to the PCMCIA device. The Status
should be Started and the Startup should be Boot. If this is not how
PCMCIA is configured, then click Startup and set the Startup Type
to Boot and click OK.
Network Driver Installation and Modem Setup
3 Shutdown the computer turn off the power.
4 Insert the PRO/100 PC Card into the PC Card slot in the com-
puter.
5 Power-up the computer.
6 Select Network from the Control Panel.
7 At the Network Settings screen click Add Adapter....
8 In the Network Adapter Card: pull-down box select <Other>
Requires disk from manufacturer and click Continue.
9 Insert Intel Disk 1, Installation Disk and make sure the specified
path is correct (see below), according to the Service Pack version
installed (see the version detection section earlier in the chapter if
you don't know what Service Pack version you have).
To Next Page
Loading...
Need help?
General
