Windows 3.x/MS-DOS Installation 4-19
2 Reboot the PC.
3 Install IBM PC LAN or IBM DOS LAN Requester according to the
instructions in the IBM documentation.
4 Reboot the PC.
Manual Installation
All network drivers provided on Intel Disk 2, Network Drivers Disk can
be installed manually, without the Intel Installation Program. You must
copy the correct driver files to your hard disk and make appropriate
changes to CONFIG.SYS, AUTOEXEC.BAT, and configuration files
such as NET.CFG (for ODI) or PROTOCOL.INI (for NDIS). Manual
installation should only be performed by a system administrator or
someone with equivalent knowledge of the installation process for
your network operating system.
Note
For manual installation of Novell NetWare with VLM (available
only under MS-DOS or Windows 3.x) you must first decompress
the VLM files by running the MS-DOS batch file
DCOMPVLM.BAT from the Network Drivers Disk, as follows:
DCOMPVLM [
PATH
]
where [path] is the directory for NetWare files (usually
C:\NWCLIENT). DCOMPVLM will decompress and copy all
required files to the designated directory.
For an overview of the installation process, see the instructions provided
for your network operating system in the alphabetical section of this
chapter. Consult the section Windows 3.x Network Driver Parameters
later in this chapter for detailed information on configuration files and
settings. For additional information, consult your network operating
system documentation.
To Next Page
Loading...
Need help?
General
