4-2 PRO/100 LAN+Modem PC Card User’s Guide
Installation under MS-DOS
For systems running MS-DOS without Windows, see Manual Installa-
tion in the Alphabetical Reference section later in this chapter.
Installation under Windows 3.x (including
Windows for Workgroups)
Run the Intel Installation Program if you are using Windows 3.1 or
Windows for Workgroups 3.11. Proceed as follows:
1 With Windows running, insert Disk 1, Installation Disk, into your
disk drive.
2 From the Program Manager, choose File, then Run. In the Com-
mand Line box, type the following:
A:SETUP
3 Press Enter or click OK.
4 Select your network operating system from the list displayed and
click OK.
5 Follow the on-screen instructions. Note the following variations for
NetWare and other network operating systems:
Novell NetWare Installation
With Novell NetWare highlighted, click the OK button. Intel
provides all software necessary to configure your NetWare client
workstation. Upon completion, the Installation Program will reboot
your system. When your system comes back up, log in to the
network.
Note
The NetWare VLM shell is used to connect to your NetWare
server. The Intel Installation Program will decompress and
configure the necessary files. If you do not plan to use the
Installation Program, see Manual Installation in the
Alphabetical Reference later in this chapter for instructions on
how to decompress and load the NetWare VLM files.
If you need NETX shell support, contact your System Adminis-
trator.
To Next Page
Loading...
Need help?
General
