4-38 PRO/100 LAN+Modem PC Card User’s Guide
ODI Settings (for driver M16BODI.COM)
Custom parameters for networks using the ODI driver can be entered
manually, using an ASCII editor, in the NET.CFG file.
DOS ODI Driver Configuration Notes (M16BODI.COM)
The ODI driver M16BODI.COM conforms to the Novell ODI Specifi-
cation: 16-bit DOS Client HSMs. It is a DOS-based
terminate-and-stay-resident (TSR) program. The driver will configure itself
according to the options specified in the NET.CFG file. This file is
supplied on Disk 2, Network Drivers Disk and must be present in the
same directory as the ODI driver. Files required for using
M16BODI.COM are
M16BODI.INS Intel installation information file
NET.CFG Network configuration file
M16BODI.COM Intel ODI driver
Most installations will be able to use the settings detected by the driver. If
any parameters need to be changed, use an ASCII text editor to open and
modify the NET.CFG file and insert the appropriate keywords and values
after the line
LINK DRIVER M16BODI
Parameters can also be implemented on the command line. Keyword
syntax can be found below. Keywords are not case sensitive. A Keyword
Alphabetical Reference follows the discussion of keyword syntax.
NET.CFG Example
LINK DRIVER M16BODI
INT 5
PORT 280
MEM D2000
To Next Page
Loading...
Need help?
General
