Interlogix Caddx User Manual

LED Keypad

GROUP BYPASS
Pressing [
BYPASS
]-[
0
]-[
BYPASS
] will bypass all zones that are designated as group
bypass zones. Press [
BYPASS
] again to exit group bypassing.
UNBYPASSING
To manually unbypass zones, perform the bypassing procedure on a zone that is
already bypassed. The corresponding light for that zone will go off when unbypassed.
NOTE: All zones will automatically be unbypassed each time the system is
disarmed.
ADDING AND CHANGING USER CODES
Your system must be
Disarmed
to change user codes.
1.
Press [
7
]-[
5
]-[“
Master Arm/Disarm” Code
].
NOTE
:
For partitioned systems, someone changing the code of another person
must have access to all or more partitions than the user being changed.
2.
The
ready light
will flash.
3.
Enter the “user number”. (Depending on the control panel in your system, this will
be either a 2-digit or 3-digit number. Remember to enter leading zeros such as
[
0
]-[
3
] for user 3, or [
0
]-[
5
]-[
2
] for user 52).
4.
The zone lights will illuminate specifying the first digit of the “user code”. (Lights
1-8 on = code is blank, lights 1-8 off = “0”, lights 1 and 8 = “9”).
5.
To DELETE a user code, enter [
7
]-[
7
]-[
7
]-[
7
] for a 4-digit code, or [
7
]-[
7
]-[
7
]-
[
7
]-[
7
]-[
7
] for a 6-digit code.
6.
The
ready light
will flash indicating you are back at Step 2 above. If the code is
rejected, the sounder will beep 3 times.
7.
Return to step 3 if another “user code” is to be programmed.
8.
Press [
#
] while the
ready light
is flashing to exit the User Code Programming
Mode.

Interlogix Caddx Specifications

General

Brand	Interlogix
Model	Caddx
Category	Security System
Language	English