LED Keypad
7.
When the partitions are assigned, press [
7
]. This returns you to Step 2. At this
point you may enter another user number to assign authority level. Repeat Steps
3 - 7 until you have assigned authority levels to all user numbers.
8.
Press [
#
] to exit the Assigning Authority Level Program.
OTHER KEYPAD FUNCTIONS
SETTING THE KEYPAD TONE
1.
Press [
7
]-[
0
]. Keypad is now in the “Adjust Tone” mode.
2.
Press [
1
] to make the keypad sounder go to higher tones, and press [
2
] to make
the keypad sounder go to lower tones.
3.
When the desired tone is reached, press [
#
] to set this tone and exit from the
“Adjust Tone” mode.
VIEW ALARM MEMORY
1.
Press [
7
]-[
3
]. The zone(s) that created the last alarm will be displayed on the
keypad.
2.
The
ALARM MEMORY
feature will flash those zones that created alarms and will
light steady those zones that were bypassed during the last alarm.
TEST FUNCTION – Optional
If programmed, this function will perform a battery test, communicator test, and/or a
siren test. Alarms and reports will not
be sent, unless a communicator test is performed
at which time a test signal will be sent.
1.
Press [
7
]-[
4
]. The test will be performed as programmed.
2.
If the siren test is performed, enter a user code to silence the siren.
To Next Page
Loading...
Need help?
General
