Copyright © Itech Electronic Co., Ltd.
IV
IT-M3400 Series User Manual
• SHOCK HAZARD Ground the Instrument. This product is provided with
a protective earth terminal. To minimize shock hazard, the instrument
must be connected to the AC mains through a grounded power cable,
with the ground wire firmly connected to an electrical ground (safety
ground) at the power outlet or distribution box. Any interruption of the
protective (grounding) conductor or disconnection of the protective earth
terminal will cause a potential shock hazard that could result in injury or
death.
• Before applying power, verify that all safety precautions are taken. All
connections must be made with the instrument turned off, and must be
performed by qualified personnel who are aware of the hazards involved.
Improper actions can cause fatal injury as well as equipment damage.
• SHOCK HAZARD, LETHAL VOLTAGES This product can outputinput
the dangerous voltage that can cause personal injury, and the operator
must always be protected from electric shock. Ensure that the outputin-
put electrodes are either insulated or covered using the safety covers
provided, so that no accidental contact with lethal voltages can occur.
• Never touch cables or connections immediately after turning off the in-
strument. Verify that there is no dangerous voltage on the electrodes or
sense terminals before touching them.
• After using the device, turn off the power switch of the device before un-
plugging the power cord or disassembling the terminals. Do not touch
the cable or the terminal immediately. Depending on the model, the dan-
gerous voltage at the plug or terminal is maintained for 10 seconds after
the device is switched off. Make sure that there is no dangerous voltage
before touching them.
• Failure to use the instrument as directed by the manufacturer may ren-
der its protective features void.
• Always clean the casing with a dry cloth. Do not clean the internals.
• Make sure the vent hole is always unblocked.
Environmental Conditions
The instrument is designed for indoor use and an area with low condensation.
The table below shows the general environmental requirements for the
instrument.
To Next Page
Loading...
Need help?
General
