ITech IT-M3400 Series User Manual

Advanced Function
set when the List running
mode is CV prioritized.
I_Lim – High limit value of negative
current, which needs to be
set when the List running
mode is CV prioritized.
V_High High limit of voltage range,
which needs to be set
when the List running mode
is CC prioritized.
V_Low Low limit of voltage range,
which needs to be set
when the List running mode
is CC prioritized.
End State Set the running state after
the List execution is
finished:
• Normal: Directly stop
the waveform output
after the execution is
finished;
• Last: Keep the last
waveform unchanged
after the execution is
finished.
Repeat Set the number and range
of running cycles of the List
file: 1–65535
Edit
Step
Edit the step parameters of List file
Current/
Voltage
Current value/voltage value
Based on the selected run-
ning mode display, set volt-
age value under the CV
mode, and set current val-
ue under the CC mode.
Slope Slope value, with setting
range of: 0.001S-3600S
Time Duration, with setting range
of: 0.001S-3600S
Next Select whether to edit the
next step: Yes/No
Insert
Step
Insert one step and set the step number to insert one
step before the step.
Add
Step
Add one step and set the step number to add one step
after the step.
Copyright © Itech Electronic Co., Ltd.
51

ITech IT-M3400 Series Specifications

General

Brand	ITech
Model	IT-M3400 Series
Category	Power Supply
Language	English