Safety Precautions
The following safety precautions must be observed during all phases of
operation of this instrument. Failure to comply with these precautions or
specific warnings elsewhere in this manual will constitute a default under
safety standards of design, manufacture and intended use of the instrument.
ITECH assumes no liability for the customer’s failure to comply with these
precautions.
Do not use the instrument if it is damaged. Before operation, check the
casing to see whether it cracks. Do not operate the instrument in the
presence of inflammable gasses, vapors or dusts.
The power supply is provided with a three-core power line during delivery
and should be connected to a three-core junction box. Before operation, be
sure that the power supply is well grounded. Make sure to use the power
cord supplied by ITECH.
Check all marks on the instrument before connecting the instrument to
power supply.
Use electric wires of appropriate load. All loading wires should be capable
of bearing maximum short-circuit of electronic load without overheating. If
there are multiple loads, each pair of the load power cord must be carry out
the full rated short-circuit output current of the power securely.
Ensure the voltage fluctuation of mains supply is less than 10% of the
working voltage range in order to reduce risks of fire and electric shock.
Do not install alternative parts on the instrument or perform any
unauthorized modification.
Do not use the instrument if the detachable cover is removed or loosen.
To prevent the possibility of accidental injuries, be sure to use the power
adapter supplied by the manufacturer only.
We do not accept responsibility for any direct or indirect financial damage
or loss of profit that might occur when using the instrument.
This instrument is used for industrial purposes. Do not apply this product to
IT power supply system.
Never use the instrument with a life-support system or any other equipment
subject to safety requirements.
To Next Page
Loading...
Need help?
General
