IT6700 User manual
User Manual
25
5.7 Save/recall Operation
Customer can save some often-used parameters in nonvolatile memory. You can use
the button (Shift)、
Recall
(Save) button or SCPI order *SAV、*RCL to achieve this
function. Saving parameters include:
1. setting voltage 2. setting current 3. OVP value 4. OCP value
Saving operation:
Press (Shift)+
Recall
(save) button(
Recall
button will flash), and then input the
group number you want to save through number key board. Press
Enter
button to
confirm.
Recall operating:
Press
Recall
button(
Recall
button will lit), and press corresponding group
number(number1-9).At last press
Enter
button to confirm.
Note: the memory capacity is 9*8, which indicate 8 memory groups and 9 memory in each
group. The memory group you use at the present should be selected in the Menu(MEM
GROUP)., refer to chapter 5.9.
5.8 Trigger operation
The trigger source of IT6700 include manual and BUS, manual means trigger by button
of the front panel, and BUS means trigger by command from the PC.
You need to select the trigger source(TRIG) from the menu before using this function.
After you edit a list file, press
(Shift)+
Enter
（Trigger）to give a trigger signal.
During the running process,
Enter
button will flash all the time.
5.9 Menu operation
5.9.1 Menu description
Press
(Shift)+
I-setI-set
(Menu) to enter the menu. You will see a optional items on
the screen, through direction keys and rotary knob to overturn VFD display, then the screen
will display the following functions .Press
Enter
button will enter corresponding items.
Press
ESC
button will return to previous menu.
MAX VOLT Set the max voltage output limit
OCP SET
OFF Disable the OCP function
ON enable the OCP function
SYST SET
P-MEM
（RESET）
Reset
Power on parameter is restored to factory
setting
Keep
Set the power-on parameter as the last
power off state
P-OUT (OFF)
OFF Set the power-on output state to be Offt
Keep
Set the power-on output state to be the last
power-off output state
To Next Page
Loading...
Need help?
General
