IT6700 User manual
User Manual
35
Interface Receiver REN_CONTROL, GO_TO_LOCAL, and LOCAL_LOCKOUT request.
Interface receive MsgID = TRIGGER USBTMC order information, and will pass TRIGGER
order to the functional layer.
Power USB488 device functions described as follows:
devices can read all of the mandatory SCPI orders.
device is SR1 enabled.
device is RL1 enabled.
device is DT1 enabled.
6.3 GPIB interface
First, Connect the GPIB interface on the power supply and the GPIB card on computer via
IEEE488 bus, must be full access and tighten the screws. Then set the address, the address
range of the power : 0 to 30, can set by the function key on the front panel, press
the
(Shift)+
I-setI-set
key to enter the system menu function, find the GPIB address setting
by
▼▼
button, type the address,
En t erEn t er
key to confirm. GPIB address is stored in
nonvolatile memory line.
Note: Forbidden to connect DB9 connector in power supply directly with PC or other RS232
port.
To Next Page
Loading...
Need help?
General
