System Commands
Copyright © Itech Electronic Co., Ltd. 11
Chapter2 System Commands
SYSTem:POSetup
This command is used to set the system power-on parameter.
Command syntax
SYSTem:POSetup RST|SAV0
Parameters
RST|SAV0
Returns
None
Query syntax
SYSTem:POSetup?
SYSTem:VERSion?
This command is used to query the current SCPI version. The returned
parameter is a string like”YYYY.V”, in which the YYYY is the year of that
version, V is the software version of that year.
Command syntax
SYST:VERS?
Parameters
None
Returns
<NR2>
Example
1991.1
SYSTem:ERRor?
This order is used to query the error information of the power supply. When the
error LED lights on the front panel, it tells us that there is one or more hardware
or order syntax error happened. There are at most 20 groups of error message.
Send the order once will read one error message from the error queue.
⚫ Error messages follow the FIFO (first-in-first-out) principle. The first error
To Next Page
Loading...
Need help?
General
