Quick start
Copyright © Itech Electronics Co., Ltd. 17
rated outputs and properly responds to operation from the front panel.
The following steps verify basic voltage functions without load.
1. Turn on the power supply.
2.
Press and numeric key to set a effective voltage,press
to confirm.
3.
Press and numeric key to set the frequency，press to
confirm.
4. Press to turn on the output。Note:When button is lit
which means the output is ON,Meanwhile indicator light of “OFF” on
VFD will disappear.
5.
check the output waveform with a oscilloscope。set different voltage
and check wether the disiplayed voltage is close to setting voltage.
6. Ensure that the voltage can be adjusted from zero to the full rated
value
To Next Page
Loading...
Need help?
General
