ITech IT7321 User Manual

IT7300 User’s Manual
Copyright © Itech Electronics Co., Ltd. iii
 Make sure the vent hole is always unblocked.
Environmental Conditions
The IT7300 series power supply can only be used indoors or in low
condensation areas. The following table shows general environmental
requirements for this instrument.
Environmental conditions
Requirement
Operating temperature
0°C
～
40°C
Operating humidity
20%～80%（non condensing）
Storage temperature
-10°C
～
70
°C
Altitude
Operating up to 2,000 meters
Installation category
II
Pollution degree
Pollution degree 2
NOTE
In order to ensure the accuracy of measurement, it is recommended to operate the
instrument half an hour after start-up.
Regulation tag
The CE tag shows that the product
complies with the provisions of all
relevant European laws (if the year is
shown, it indicates that the year when
the design is approved).
This instrument complies with the WEEE
directive (2002/96/EC) tag
requirements. This attached product tag
shows that the electrical/electronic
product cannot
be discarded in
household waste.
This symbol indicates that no danger
will happen or toxic substances will not
leak or cause damage in normal use
within the spec
ified period. The
service life of the product is 10 years.
The product can be used safely within
the environmental protection period;
otherwise, the product should be put
into the recycling system.
Waste electrical and electronic equipment (WEEE) directive
Waste electrical and electronic equipment (WEEE) directive,
2002/96/EC
The product complies with tag requirements of the WEEE
directive (2002/96/EC). This tag indicates that the electronic
equipment cannot be disposed of as ordinary household
waste.

ITech IT7321 Specifications

General

Brand	ITech
Model	IT7321
Category	Power Supply
Language	English