ITech IT7622 Programming Guide

System Commands
Copyright© Itech Electronic Co., Ltd. 53
Chapter8 Output Commands
[SOURce:]OUTPut[:STATe]
This command is used to control the output switch state.
Command syntax
[SOURce:]OUTPut[:STATe] <A|ALL>,<0|1|OFF|ON>
Arguments
<A|ALL> phase
<0|1|OFF|ON> Output state
Example
OUTP A,1
Query syntax
[SOURce:]OUTPut[:STATe]? < A|ALL >
Returns
<0|1|OFF|ON>
[SOURce:]OUTPut[:STATe]?
This command is used to query the output switch state.
Command syntax
[SOURce:]OUTPut[:STATe]?<A|ALL>
Arguments
<A|B|C|ALL>
Example
OUTP? A
Returns
0|1|OFF|ON
[SOURce:]RELAy:MODE
This command is used to set the relay mode of a phase (Normally Open,
Normally Close).

ITech IT7622 Specifications

General

Brand	ITech
Model	IT7622
Category	Power Supply
Language	English