ITech IT7622 Programming Guide

System Commands
Copyright© Itech Electronic Co., Ltd. 77
Chapter11 List Operation Commands
LIST:REPEat
This command is used to set the running times of list file.
Command syntax
LIST:REPEat <value>
Arguments
<value> : Running repetitions
Query syntax
LIST:REPEat?
Returns
<vaule>
LIST:ENDState
This command is used to set end of LIST
Command syntax
LIST:ENDState <0|1>
Arguments
<0|1> ：0 Stop output, 1 Keep last state
Query syntax
LIST:ENDState?
Returns
<0|1>
LIST:JUMPto
This command is used to set the jump when single cycle of list ends.
Command syntax
LIST:JUMPto <value>
Arguments
<value>：list Start position of next list when previous running ends.

ITech IT7622 Specifications

General

Brand	ITech
Model	IT7622
Category	Power Supply
Language	English