To Next Page

To Previous Page

Operation and Application

5.3.2 DC Output Mode

If the output mode select to DC Mode, the instrument will simulate DC power

supply. Set the output voltage and current of the DC power supply in the main

interface, as shown in the figure below.

z Press up/down keys to select setting value and then press Enter to confirm.

z Rotate the knob to select setting value and then press Enter to confirm.

z Touch screen and then press Enter to confirm.

5.3.3 AC+DC Mode

If the output mode select to AC+DC Mode, the instrument will simulate AC and

DC power supply, which can add DC component to AC voltage. Set the output

voltage in the main interface, as shown in the figure below.

ITech IT7900 Series User Manual

Other manuals for ITech IT7900 Series