Inspection and Installation
Copyright ©ITECH Electronic Co., Ltd. 76
conflict with any instrument on the interface bus. This setting is nonvo- latile; it will
not be changed by *RST.
When you purchase the interface accessory and successfully insert it into the
corresponding position on the rear panel of the instrument, the menu item for
changing the GPIB address appears in the System menu. The specific steps are as
follows:
1.
Ensure that the instrument's power switch is off, that is, the instrument is
in Power Off state.
2.
Insert the separately purchased GPIB interface card into the card slot on the
rear panel of the instrument.
3.
Connect the instrument with the computer via the GPIB cable. After the con-
nection is successful, turn on the power switch of the instrument.
4.
Press the composite keys [Shift]+ (System) on the front panel to
en- ter the system menu.
5.
Select Communication and press [Enter].
6.
Select GPIB and press [Enter].
7.
Press the numeric keys to set the GPIB address and press [Enter].
10.5 RS–232 Interface (Optional)
The RS-232 interface shares the same communication card (IT-E177) with the analog
function.
Definition of RS-232 Pins
The definition of RS-232 pins are as follows.
When using the RS-232 interface for communication, connect the pin 1, pin 2, and
pin 3 of the IT-E177 to the PC. The pin description is as follows:
1
TXD, transmit data
Description
To Next Page
Loading...
Need help?
General
