ITech IT8625 Manual

IT8600 Programming Guide
Copyright © Itech Electronic Co., Ltd. ii
Safety Precautions
The following safety precautions must be observed during all phases of
operation of this instrument. Failure to comply with these precautions or specific
warnings elsewhere in this manual will constitute a default under safety
standards of design, manufacture and intended use of the instrument. ITECH
assumes no liability for the customer’s failure to comply with these precautions.
 Series IT8600 electronic load supports 110V/220VAC input and no need to
switch.
 Do not use the instrument if it is damaged. Before operation, check the
casing to see whether it cracks. Do not operate the instrument in the
presence of inflammable gasses, vapors or dusts.
 The electronic load
is provided with a three-core power line during delivery
and should be connected to a three-core junction box. Before operation, be
sure that the electronic load is well grounded.
 Make sure to use the power cord supplied by ITECH.
 Check all marks on the instrument before connecting the instrument to
power supply.
 Use electric wires of appropriate load. All loading wires should be capable
of bearing maximum short-circuit of electronic load without overheating. If
there are multiple loads, each pair of the load power cord must be carry out
the full rated short-circuit output current of the power securely.
 Ensure the voltage fluctuation of mains supply is less than 10% of the
working voltage range in order to reduce risks of fire and electric shock.
 Do not install alternative parts on the instrument or perform any
unauthorized modification.
 Do not use the instrument if the detachable cover is removed or loose.
 To prevent the possibility of accidental injuries, be sure to use the power
adapter supplied by the manufacturer only.
 We do not accept responsibility for any direct or indirect financial damage
or loss of profit that might occur when using the instrument.
 This instrument is used for industrial purposes, Do not apply this product to
IT power supply system.
 Never use the instrument with a life-support system or any other equipment
subject to safety requirements.
 Failure to use the instrument as directed by the manufacturer may render
its protective features void.
 Always clean the casing with a dry cloth. Do not clean the internals.
 Make sure the vent hole is always unblocked.
Environmental Conditions
The instrument is designed for indoor use and an area with low condensation.
The table below shows the general environmental requirements for the
instrument.

ITech IT8625 Specifications

General

Brand	ITech
Model	IT8625
Category	Test Equipment
Language	English