IT8600 User Manual
Copyright © ITECH Electronic Co., Ltd. ii
Frame or chassis terminal
Safety Precautions
The following safety precautions must be observed during all phases of
operation of this instrument. Failure to comply with these precautions or specific
warnings elsewhere in this manual will constitute a default under safety
standards of design, manufacture and intended use of the instrument. ITECH
assumes no liability for the customer’s failure to comply with these precautions.
⚫ Do not use the instrument if it is damaged. Before operation, check the
casing to see whether it cracks. Do not operate the instrument in the
presence of inflammable gasses, vapors or dusts.
⚫ The instrument is provided with a power cord during delivery and should be
connected to a socket with a protective earth terminal, a junction box or a
three-phase distribution box. Before operation, be sure that the instrument
is well grounded.
⚫ Make sure to use the power cord supplied by ITECH.
⚫ Check all marks on the instrument before connecting the instrument to
power supply.
⚫ Use electric wires of appropriate load. All loading wires should be capable
of bearing maximum short-circuit of electronic load without overheating. If
there are multiple loads, each pair of the load power cord must be carry out
the full rated short-circuit output current of the power securely.
⚫ Ensure the voltage fluctuation of mains supply is less than 10% of the
working voltage range in order to reduce risks of fire and electric shock.
⚫ Do not install alternative parts on the instrument or perform any
unauthorized modification.
⚫ Do not use the instrument if the detachable cover is removed or loose.
⚫ To prevent the possibility of accidental injuries, be sure to use the power
adapter supplied by the manufacturer only.
⚫ We do not accept responsibility for any direct or indirect financial damage
or loss of profit that might occur when using the instrument.
⚫ This instrument is used for industrial purposes, Do not apply this product to
IT power supply system.
⚫ Never use the instrument with a life-support system or any other equipment
subject to safety requirements.
⚫ SHOCK HAZARD Ground the Instrument. This product is provided with a
protective earth terminal. To minimize shock hazard, the instrument must
be connected to the AC mains through a grounded power cable, with the
ground wire firmly connected to an electrical ground (safety ground) at the
power outlet or distribution box. Any interruption of the protective
(grounding) conductor or disconnection of the protective earth terminal will
cause a potential shock hazard that could result in injury or death.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
