IT8600 User Manual
Copyright © ITECH Electronic Co., Ltd. iii
⚫ Before applying power, verify that all safety precautions are taken. All
connections must be made with the instrument turned off, and must be
performed by qualified personnel who are aware of the hazards involved.
Improper actions can cause fatal injury as well as equipment damage.
⚫ SHOCK HAZARD, LETHAL VOLTAGES This product can input the
dangerous voltage that can cause personal injury, and the operator must
always be protected from electric shock. Ensure that the input electrodes
are either insulated or covered using the safety covers provided, so that no
accidental contact with lethal voltages can occur.
⚫ Never touch cables or connections immediately after turning off the
instrument. Verify that there is no dangerous voltage on the electrodes or
sense terminals before touching them.
⚫ Failure to use the instrument as directed by the manufacturer may render
its protective features void.
⚫ Always clean the casing with a dry cloth. Do not clean the internals.
⚫ Make sure the vent hole is always unblocked.
Environmental Conditions
The instrument is designed for indoor use and an area with low condensation.
The table below shows the general environmental requirements for the
instrument. The speed of fan will change intelligently by the temperature of
radiator. When the temperature is up to 40°C, the fan will be on and adjust
intelligently when temperature changes.
20%-80% (non-condensation)
NOTE
To make accurate measurements, allow the instrument to warm up for 30 min before
operation.
Regulatory Markings
The CE mark is a registered trademark of
the European Community. This CE mark
shows that the product complies with all the
relevant European Legal Directives.
The instrument complies with the WEEE
Directive (2002/96/EC) marking
requirement. This affixed product label
indicates that you must not discard the
electrical/electronic product in domestic
household waste.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
