Communication Interfaces
Copyright © ITECH Electronic Co., Ltd. 79
Chapter9 Communication Interfaces
Three standard interfaces are equipped for IT8600: GPIB, USB and LAN. Users
can choose any of the USB, GPIB and LAN to achieve the communication with
PC.
9.1 USB Interface
Use cables with both USB ends to connect with IT8600 and PC. All electronic
load functions are programmable over the USB.
The USB488 interface capabilities are described below:
⚫ The interface is 488.2 USB488 interface.
⚫ The interface accepts REN_CONTROL, GO_TO_LOCAL, and
LOCAL_LOCKOUT requests.
⚫ The interface accepts MsgID = TRIGGER USBTMC command message
and forwards TRIGGER requests to the function layer.
The USB488 device functions are described below:
⚫ The device understands all mandatory SCPI commands.
⚫ The device is SR1 capable.
⚫ The device is RL1 capable.
⚫ The device is DT1 capable.
9.2 GPIB Interface
First connect GPIB interface to GPIB card of PC with IEEE488 BUS. They must
be sufficient contact and tighten the screws. Press [Menu] key to enter system
menu, press [COMM CONFIG] to find Communication interface. Select GPIB,
and then set the GPIB address. The address can be set from 0 to 30. Press
[Enter] to confirm. The electronic load operates from a GPIB address set from
the front panel. The GPIB address is stored in non-volatile memory.
9.3 LAN Interface
Press [Menu] on the front panel to access the menu. Select [COMM CONFIG]
to enter communication configuration page. Select LAN by pressing up/down
keys and then configure Gateway, IP, Mask and Socket Port in the LAN options.
Use a cross network cable through LAN interface to connect PC.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
