To Next Page

To Previous Page

Load Functions

⚫ Pset=50.0W: constant power of CP Mode.

⚫ CF=1.414: crest factor, 1.414 to 5.000.

⚫ PF=1.000: power factor. It cannot be edited.

5. Press [Enter] to confirm.

6. Press [On] to enable load input. Loading will be started and the current will

sink.

PF Mode

⚫ Mode setting

The initial default mode of IT8600 electronic load is the “BOTH” mode. PF Mode

can be set in the same method as in CC Mode. Refer to 4.2.2 “Constant Current

Mode”.

⚫ CP parameter setting

The user can press the Up and Down key in the main interface of CP Mode to

select the parameter to be set, including PF and Pset. The user can also rotate

the knob to set the current value or press numeric keys to input the set value.

The PF range is -1.000 to 1.000.

1. Press [Set] to enter the parameter setting interface of CC Mode.

2. Press the soft key corresponding to CP to enter the CP mode setting

interface.

3. Press the Up and Down key to select the parameter to be set.

4. Directly set the present value through the knob or press numeric keys to

input the value. In case of wrong input by numeric keys, press to

delete the present input.

ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT8625 User Manual

Other manuals for ITech IT8625