ITech IT8700 Series User Manual

Panel function introduction
Copyright © Itech Electronic Co., Ltd. 27
level）
Off 〈Default〉
Disable this function
Ext. Ctr1 Set
External analog control function
On
Turn on external analog control function
Off 〈Default〉
Turn off external analog control function
Rem Sense Set
Remote measuring
On
Enable remote sense function
Off 〈Default〉
Disable remote sense function
About
Module production information
IT87XX
Channel production model
VER: X.XX
Channel software version
SN:
XXXXXXXXXXXXX
Channel production serial number
EXIT
System menu
Press + key to enter system menu function
MENU
Initialize
Initialize Default Set
Resume all configuration to default
Power On Set
RST <Default>
Set the load’s input state to be the default state
when power on
SAV0
Set the load’s input state to be that of SAVE 0 set
when power on
Buzzer Set
Setup the buzzer state
ON <Default>
enable the function
OFF
disable the function
Load On Knob
Module knob mode setting
Updated <Default>
Real-time Update
OLD
No update（ when ON/OFF resume the original
value）
Trigger Sour.
Setup the trigger mode
MANUAL〈DEF〉
Manual trigger
EXTERNAL
External signal trigger mode
HOLD
Trig: IMM available
BUS
GPIB bus trigger mode
TIMER
Timer trigger
Trigger Timer
Trigger time setting
TRIGGER TIMER SET
Setup the time of the trigger timer
Communication
Select the port to communicate with a computer
RS232〈DEFAULT〉
USB TMC-USB488
GPIB
ETHERNET
RS232 SET
Baudrate Set
Setup the communication baud rate
4800 <Default>
9600
19200
ShiftShift
44

ITech IT8700 Series Specifications

General

Brand	ITech
Model	IT8700 Series
Category	Test Equipment
Language	English