Operations introduction
Copyright © Itech Electronic Co., Ltd. 44
Fig 4-8 toggled mode current waveform
4.4.4 A/B transient operations
The following will show you how to set operation mode on front panel. Take CC
mode as an example:
1. Power on the electronic load
2. Press 、 keys to select the channel to be edited, such as
channel 1
CH01 CC OFF
Vdc=0.0000V
Adc=0.0000A
Wdc=0.00W
3. Press key to enter the channel setup menu, press key to
enter the mode selection menu <Mode>, press key to select the
mode CC/CV/CR/CW，such as CC，press key to confirm
CH01
Mode=CC
RANGE=HIGH
Iset=9.000A
4. Press key to enter range setting <Range>, press key to
enter the mode selection menu <Mode>, press key to select, such
as <low range>, press key to confirm.
CH01
High Range
Low Range
5. Press key to enter the rise slope <∫>, such as set the current to be
1A/uS，press key to confirm
CH01
Rise Speed Set
= 1.00A/Us
6. Press key to enter the fall slope setting <∫>, such as set the rise
slope to be 2A/uS. Press key to confirm
CH01
Fall Speed Set
= 2.00A/Us
7. Press key to enter A LEVEL setting <TRANa>，such as 10.00A,
press key to confirm
Transition A
Level = 10.00A
8. Press key to enter A level width setting <Ta>，such as 0.003S，
To Next Page
Loading...
Need help?
General
