Warning! The primary consideration when installing the IMR Mounting Jacket is that
the IMR be securely attached to the vehicle. Failure to do so could lead to injury or
death from unsecured components during a sudden stop, rollover, or collision.
The following procedures describe several possible mounting configurations.
Installing on a Lap Seat Belt
Attach the Mounting Jacket to the lap seat belt using the seat belt retaining flap as shown below.
The Mounting Jacket may be installed with the top of the jacket facing either way.
Warning! For safety, the Mounting Jacket should only be attached to a lap seat belt.,
Attaching it to a shoulder belt may allow the IMR-FT to swing unrestrained, causing a
potential hazard.
Caution: When the IMR-FT is installed on a lap seat belt, do not place other items on
top of the IMR-FT or its cables. Do not allow passengers to sit on the IMR-FT or to
wear a seat belt with an IMR-FT attached to it.
Installing on a Partition or Other Vehicle Structure
1. Attach the supplied mounting plate to the Mounting Jacket in the orientation most useful for
your purpose using the screws supplied by Itron. Torque the screws to 17-19 in. lbs.
2. Using cable ties, two ¼-inch bolts, or some other secure fasteners, attach the mounting plate
to the vehicle partition or other suitable vehicle structure. (Fasteners are not supplied by
Itron.)
01 September 2020 815-0410-00 29
Itron Mobile Radio User Guide Chapter 7 Installing the IMR-FT
To Next Page
Loading...
General