Installing on a Pedestal
Attach the Mounting Jacket to a pedestal device mount with the screws supplied by Itron. Torque
the screws to 17-19 in. lbs.
The pedestal device mount must match the universal AMPS hole pattern used by the Mounting
Jacket. (Itron does not supply pedestal device mounts.)
Installing the IMR-FT in the Mounting Jacket
1. Place the IMR-FT in the Mounting Jacket and engage the plastic side release buckles.
2. Ensure the IMR-FT is securely enclosed in the Mounting Jacket and tighten the straps, if
necessary.
3. After installing the IMR-FT in the Mounting Jacket, plug the micro-USB cable into the IMR-
FT and secure the cable with the cable retaining flap.
4. Attach the DC power cable and antenna cable to their connectors on the charge base.
Note: The DC power cable connector and antenna cable connector should only be
finger tightened. Do not tighten the connectors with a tool.
When complete, your IMR-FT installation should look like this:
01 September 2020 815-0410-00 30
Itron Mobile Radio User Guide Chapter 7 Installing the IMR-FT
To Next Page
Loading...
General