D.12 DIAL MODE
You can set your phone to use either Tone or Pulse dialing. The pre-set setting is Tone dialing,
where you will hear a tone beep each time you dial a number. Most modern exchanges and
switchboards use Tone dialing, so you should not need to change this setting. Only change it if
your switchboard uses Pulse dialing or if you cannot make a call using Tone dialing.
Key Map:-
Æ Base Settings – Æ AdditionalÆ Æ Dial ModeÆ Æ select
Tone/PulseÆ
1. Press the
button to access the main menu.
2. Press
/ button to select “Base Settings”. Press button.
3. Press
/ button to select “Additional” . Press button.
4. Press
/ button to select “Dial Mode” .Press button. The current setting
is displayed.
5. Press
/ button to select either “Tone” or “Pulse”. Press button to
confirm.
6. Press the
button to exit and return to standby mode.
Tone dialing Switch-Over
If you have set your phone to use Pulse dialing, you can switch temporarily to Tone dialing for the
duration of a call:
1. Press
button.
2. Enter the number you want. Press and hold
“D” will be displayed. Any digits entered
after the “D” will be dialed using tone dialing.
D.13 PREFIX DIALING
If you need to add a prefix to the number for a long distance call, or if you need to add your saved
area code to the number, do the following:
To Next Page
Loading...
Need help?
General
