I. ADVANCED OPERATION
Special Attention!!!
Following sections are only for users who are familiar with electronics products.
Failure in following steps correctly may stop your DECT phone from normal operation.
I.1 REGISTERING A NEW HANDSET
When you register a new handset to your base, you will be asked to enter your base PIN code.
To enable registration mode on base unit, press and hold the
button for 5 seconds.
Before registering, make sure the new handset is fully charged and that you have the base and
handset in front of you. Also, make sure all handsets and the base are in standby.
On the handset you want to register:
Key Map:-
Æ Add. Settings – Æ RegisterÆ Æ select the base numberÆ
1. Press button to access the main menu.
2. Press
/ button to select “Add. Settings” and press .
3. Press
/ button to display “Register” press to confirm.
4. Press / button to select your base number and press to confirm.
If the base already has the maximum number of 6 handsets registered to it you will need to
de-register one of the existing handsets before you can register the new handset.
See the section for de-registering handsets.
On the handset:
Enter the base PIN code.
Pre-set base PIN code is 0000.
You will hear a confirmation tone when registration is complete.
When in standby, the new handset number will be displayed.
To Next Page
Loading...
Need help?
General
