Jacobsen GA 24 User Manual

5 OPERATION
12
5.3 OPERATING PROCEDURES_________________________________________________
1. Before starting engine, always release OPC handle.
2. Do not operate aerator or attachments with loose,
damaged or missing components.
3. First aerate in a test area to become thoroughly
familiar with the operation of the unit and control
levers.
4. Study the area to determine the best and safest
operating procedure. Consider the type of terrain
and condition of the surface. Each condition will
require certain adjustments or precautions.
5. Never direct discharge of material toward
bystanders, nor allow anyone near the machine
while in operation. The owner/operator is
responsible for injuries inflicted to bystanders and/or
damage to their property.
6. Use discretion when operating near gravel areas
(roadway, parking areas, cart paths, etc.). Stones
struck by the unit may cause serious injuries to
bystanders and/or damage the equipment.
7. Always raise aerator head and move control lever
out of L position when not aerating.
8. Disengage the tines and raise the aerator head
when crossing paths or roadways. Look out for
traffic.
9. Stop and inspect the equipment for damage
immediately after striking an obstruction or if the
machine begins to vibrate abnormally. Have the
equipment repaired before resuming operation.
10. Slow down and use extra care on hillsides. Read
Section 5.7. Use caution when operating near drop
offs.
11. Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure vision.
12. Never use your hands to clean aerator. Tine edges
are sharp and can cause serious injuries.
5.4 STARTING _______________________________________________________________
1. Check engine crankcase oil levels.
2. Fill fuel tank with fresh, clean unleaded fuel.
3. Turn engine switch to ON position.
4. Place Shift Control Lever (C) in neutral, and
disengage clutch control (A).
5. Move Throttle lever (B) to 1/2 throttle.
6. Pull recoil starter located on right side of engine.
Choke as required to start engine.
7. Allow the engine to become warm and properly
lubricated before operating at high RPM.
Figure 5A
CAUTION
To prevent injury, always wear safety glasses, leather work shoes or boots, a hard hat, and ear protection.
!
CAUTION
Before operating, pick up all debris such as rocks,
toys, and wire which can be thrown by the machine.
Enter a new area cautiously. Always operate at
speeds that allow you to have complete control of the
unit.
!
WARNING
Before you clean, adjust, or repair this
equipment, always disengage all drives, lower
aerator head to the ground, stop engine and
disconnect spark plug wire to prevent injuries.
!
A
L
H
N
R
C
D
B
E

Jacobsen GA 24 Specifications

General

Brand	Jacobsen
Model	GA 24
Category	Tiller
Language	English