en-75
ADJUSTMENTS 7
7.8 SEAT (GRAMMER MSG85) ____________________________________________
To get a good seat position to operate the machine you need to adjust the leg
reach, the backrest angle and the operator weight.
A. FRONT AND REAR ADJUSTMENT
To Adjust:
The adjusting lever (A) is on the right side of the seat. Lift the lever and the
seat can move backward and forward. When the seat is in the correct position,
release the lever to put the seat into one of the preset positions.
B. BACKREST ADJUSTMENT
To Adjust:
The position of the release lever (B) is on the left side of the seat. When the driver is on the seat, lift the release
lever to release the backrest. The backrest is spring loaded to fold on to the seat cushion. Move backward in the
seat to get the correct position for the backrest. Lower the release lever to put the seat into one of the preset
positions.
C. WEIGHT ADJUSTMENT
To Adjust:
The position of the operator weight adjust lever (C) is on the front of the seat. To change the operator weight
setting with the driver on the seat, lift and rotate the lever.
D. HEIGHT ADJUSTMENT
To adjust:
Adjust the height when you are on the seat. Hold the edge of the seat cushion and lower the seat. Lift when the
cushion and the suspension returns to its normal position. There are three preset positions for the seat. When the
seat has lifted to the highest position, the seat returns to its lowest position.
NOTE:The seat has a microswitch to sense the operator in the seat.
When the machine has a ROPS frame or a ROPS cab, the driver must wear the lap belt that is installed in the
machine.
To Next Page
Loading...
Need help?
General
