Jacuzzi J-200 User Manual

J-200
D. Ready-in-Rest Mode
When the spa is in a Rest Mode “ ” and the Jets
Pump 1 button is pressed, the spa will heat to either
the set temperature or for one hour. Both icons will be shown on the
display. After the 1-hour time out and automatic clean up cycle the spa
will return to Rest Mode.
11.3 Adjusting and Setting the Time
The time on the spa can be programmed. This is needed in order for the
spa to run during a programmed lter cycle.
• The default time is for 12:00 noon.
• The default setting is for a 12-hour conguration. See Preference
settings for selecting a 12-hour or 24-hour display, page 38.
• The time information is not stored. If power is cut to the spa you
must reset the time.
A. Set Time
Note: If no button is pressed within 5 seconds of each
selection the screen will revert back to the Main Menu and the current
settings will remain active.
1. Press 3 times until you get to the “SET TIME/TIME” Menu. The
display will scroll “SET TIME” at start up or anytime the power to the
spa is turned off and on.
2. Press or to prepare the system for changes.
3. The display will change from “SET TIME” to . The hour will be
ashing. Press or to adjust the hour. In the upper right-hand
corner, an or will display. This indicates either AM or PM.
4. Press to set the minutes. The display will change from to
. The minutes will be ashing. Press or to adjust the
minutes. Press to accept the change and return to the main.
5. To check the time, press the Menu button until you get to the Time
Menu. The display will alternate between “TIME” and the current time.
11.4 Invert the display
From the Main Menu, press the button until you reach the “FLIP”
option. Press or to invert the display from to .
Press to accept the change and return to the main.
11.5 Locking the Spa
Certain functions and features can be locked to prevent
unauthorized use.
• Temperature lock: The set temperature and programming settings
cannot be adjusted. Jets can be activated. The following menus can
be accessed: FLIP, LOCK, UTIL, INFO, and FALT LOG, if equipped.
When trying to adjust the temperature, “LOCK” will appear.
34

Jacuzzi J-200 Specifications

General

Brand	Jacuzzi
Model	J-200
Category	Hot Tub
Language	English