J-200
11.7 Programming the Filtration Cycles
The ltration cycles and CLEARRAY® unit are important to
ensure healthy water conditions. You can program up to 2 lter
cycles.
Note: Make sure to set the time so the cycles can run as programmed.
• Before a ter cycle runs, a brief blow-out cycle will active to clear
the plumbing lines.
• Run times are adjusted in 1-hour increments. The minutes are
adjusted in 15-minute increments.
• The segment being programmed will continually ash.
• If power is cut to the spa, the programming cycles will be stored.
• If power is cut to the spa, the ltration cycles programming will be
stored. The “SET TIME” will need to be reprogrammed.
In extreme bitter cold weather, where freezing can occur,
we recommend you program the ltration cycles to run for
a minimum of 8 hours per day. Refer to the “Winterizing”
section on page 44.
A. Filter Cycle 1
Filter cycle 1 has a default start time for 8:00 PM for 4 hours. To change
the setting follow the steps below.
1. From the Main Menu, press the button until you reach the Filter
Cycle 1 Menu.
2. Press or to enter the menu. The display will show .
3. Press or to program to start to cycle. The display will show
. Press or to make adjustments. In the upper right-
hand corner, an or will display. This indicates either AM or PM.
You must round the clock to change from am to pm.
4. Press the button to move on the minutes. Press or to
program the minutes. The display will show .
5. Press the button to program the cycle length. The display will
show . Press or to enter the menu.
6. Press or to program the hour(s) duration of the cycle. The
display will show .
7. Press the button to program the minutes for the cycle. The
display will show . Press or to make adjustments.
8. Press the button. The display will show, “F1 ENDS 11:45.” The
system calculates the end time base of the hours programmed.
9. Press or to accept the changes and return to the Main Menu.
36
To Next Page
Loading...
Need help?
General
