J-200
• Panel lock: All automatic functions will still run but the control panel
buttons will not activate. When the panel is locked, the display
will show the current temperature but when any button is pressed
“LOCK” will appear.
A. Locking the Temperature
1. From the Main Menu, press the button until you reach
the “LOCK” option.
2. Press or to enter the “LOCK” Menu.
3. Press or to enter the “TEMP” Menu.
4. Press or to toggle between “OFF” and “ON.”
5. Press the button to accept the change and return to the Main Menu.
B. Locking the Panel
1. From the Main Menu, press the button until you reach
the “LOCK” option.
2. Press or to enter the “LOCK” Menu.
3. Press or to enter the “TEMP” Menu.
4. Press the button to enter the “PANL” Menu.
5. Press or to toggle between “OFF” and “ON.”
6. Press the button to accept the change and return to the Main
Menu.
C. Unlocking the Temperature/Panel
1. From the Main Menu, press and hold the button then
slowly press the button twice. “UNLK” will display and
after a few seconds the Main Menu will be displayed.
2. If both the temperature and panel are locked, you will need to
perform the unlock procedure twice.
11.6 Hold (Standby)
This feature is used when performing a service or replacing the
lters. The setting lasts for an hour unless you manually exit.
1. From the Main Menu, press the button until you reach the
“HOLD” option.
2. Press or to enter the menu. The following message will keep
scrolling until the hour is up or you manually exit, “HOLDING FOR
1:00.”
3. To exit the setting before the hour is up, press either the , or
button. You will return to the Main Menu.
35
To Next Page
Loading...
Need help?
General
