30
Press the JETS key:
If the water remains still, check the level and make sure the
spa is plugged in. If it does not solve the problem, contact your
authorized dealer.
The main pump operates but no water flows from the jets.
Pump may not be properly primed.
This can happen after the spa is drained and refilled.
Press the JETS 1 button several times, never leaving the mo-
tor on for more than 5 to 10 seconds at a time.
Disconnect the power supply and remove the filter (and the
dispenser, if present; see “Dispenser for water sanitation”).
Make sure that first you have reinstalled the filter before con-
necting the spa to the power supply and restarting the pump.
Poor jet action.
Press the JETS 1 button to make certain the pump 1 is on.
Place the air control in the “on” position.
Check that filter is not dirty and clean as necessary.
Make sure jets are fully open.
Water is too hot
Reduce temperature setting so the circulation pump turns
off.
Water is too cold
Check temperature setting.
Keep the spa cover in place while heating.
Check the settings to see if your spa is in economy mode (see
chapter "Filter cycles").
Should checking the above steps fail to correct the problem,
please call an authorized dealer or service center.
Stereo receiver (optional)
1. Power Button: Press PWR (Power) to turn deck on or off.
2. Open Button: Press Open to flip down the front access pa-
nel for CD access. Gently insert CD into slot (DO NOT FORCE!)
Make sure to close the front panel to prevent damage to the u-
nit
Note: Never insert a wet or moist CD since it may damage the
mechanism and void the manufacturer warranty.
- Eject Button (Not Illustrated): After releasing the front panel,
press the Eject button located to the left of CD slot to eject the
CD. The unit does not have to be on to eject the CD.
- Reset button (Not Illustrated): After releasing the front pa-
nel, use a pencil or any nonmetallic object to press and hold the
reset button for five seconds to reset the main unit and the unit will
return to the factory default settings.
3. Top Button: Has no function.
4. Mute Button: Press Mute to mute audio output. The word
Mute flashes on the display panel. Press again to return to pre-
vious volume level.
5. Menu Function List Button: Press Menu to navigate th-
rough the list of stereo performance functions. Steps to access
menu items:
- To access the MENU press the Menu button < 3 seconds;
“MENU” will be displayed for 2 seconds, and then “CONTRA-
ST” will appear on the display.
- To navigate through the menus use the or buttons or
press the MENU button repeatedly..
- To adjust the selected menu item, press the VOLUME Up (7)
or Down (8) buttons.
- After the selected menu item(s) has been changed and no
other buttons have been pressed within the 5 second time-out,
the unit will resume to the previous operation.
Contrast: “CONTRAST 5” will be displayed by default. The u-
ser now has 5 seconds to press the VOLUME Up or Down but-
tons to adjust from 0 – 10.
Dimmer: The dimmer feature of the display is set to “DIMMER
High” by default. Use the Volume Up or Down buttons to adju-
st the Dimmer level between High or Low.
Distant/Local: “Distant” is the default setting. User now has
SAT INFO
AS-PSXBAS
2
ZONE
SUBWBAND
S
E
A
R
C
H
INT RPT RDM
AUDIO
ENTER
MODE
MULTI-
ENVIRONMENT
PLAYER
TOP MENU
AQ-CD-3
10
15 16 17 18 19 20 8 1 96 4
11 12 13 14 2 22 217 3 5
To Next Page
Loading...
Need help?
General
