109
In the event of difficulty...
THE HYDROMASSAGE DOES NOT START
First of all, check that the main switch on the power supply
line of the tub is on and that there is not a power outage. Also
make sure you have complied with the instructions provided in
the relative chapter. Make sure the remote control is pointed at
the receiver when confirming function start-up.
If there are any other irregularities, please refer to the following
instructions.
Defects concerning the electronics box
• Pump does not start
• The LED for the key on the receiver flashes.
• Aim the remote control at the receiver and hold down the
key for about four seconds. The display will show the
screenshot as indicated.
Contact a Jacuzzi
®
service centre .
To return to normal remote control display, press any key.
Electronic safety cut-out protection in operation.
• Pump does not start
• The LED next to the key on the receiver flashes.
• Aim the remote control at the receiver and hold down the
key for about four seconds. The display will show the
screenshot as indicated.
To restore normal operation of the tub, hold down the indi-
cated key for about six seconds.
If the protection trips again when functions are restarted, con-
tact a Jacuzzi service centre.
To return to normal remote control display, press any key.
Insufficient water level
• The water in the tub is below the required level and the pump
is stopped.
• The LED for the key on the receiver flashes.
• Aim the remote control at the receiver and hold down the
key for about four seconds. The display will show the
screenshot as indicated.
You will need to add the required amount of water and re-
peat the steps described in the chapter on the hydromassage.
Make sure you turn the remote control off and then back on.
Incorrect position of distributor valve
During selection of the various hydromassage cycles, if this
valve is incorrectly positioned, the cycle will not proceed.
To Next Page
Loading...
Need help?
General
