83
- Once you have decided which frequencies you want to mem-
orize (from among those identified by searching as described
above), press the key or to move the flashing cur-
sor to MEM1, MEM2 or MEM3.
- While aiming the remote control at the receiver, press the
key
.
To recall a previously memorized frequency, put the flashing
cursor on the selected station (MEM1, MEM2 or MEM3) and
press the key (again while aiming the remote control at
the receiver).
Turning off the radio
Use the keys or to place the flashing cursor on
I/O (at upper left).
While aiming the remote control at the receiver as shown in
the figure, press the key.
• During radio operation, all other functions of the JSha Mi can
be used.
• The maximum operating time for the radio is about 60 min-
utes. After that time, it shuts off automatically. To turn it back
on, refer to the instructions provided above.
• Any changes made in radio volume are not saved when the
radio is turned off. Therefore, when the radio is turned back
on, the radio volume will be at the factory pre-set level.
NOTE
To Next Page
Loading...
Need help?
General
