27
NOTE: after wards, if the level of water in the compensation
tanks drops below the minimum level, the solenoid valve will
restore the operating level.
Check the operation of the hydromassage pumps with the
keys: “Pump1” and “Pump2” .
Check blower operation by pressing the key “Blower” .
Check that the spotlights switch on and off using the key
“Light” .
Completely disinfect the spa by carrying out “super-chlorination”
treatment.
Please refer to the Jacuzzi system water treatment
guide and relative catalogue for details on water qual-
ity maintenance, the methods and warnings governing
the use of relative chemical products.
After a few hours, turn off the omnipolar switch(es).
Open the discharge valves and drain the spa.
ATTE NTION
Do not use the spa the first time you start it as there
is a high concentration of chlorine in the water dur-
ing this phase. Immediately empty the bath.
Contact the local authorities for the standards
governing the discharge of chemically treated
water.
Refill the spa, following the previously described procedure.
Turn the omnipolar switch(es) back on and set the filtering cy-
cles according to client needs. Establish a water treatment
schedule.
MANAGEMENT OF FUNCTIONS
CONTROL PANEL
All spa functions are managed by the control panel on the tub, as
are the respective settings/programming.
When the system is powered on, the display shows the time
alternating with the temperature in the tub.
If the electric heater is in operation, the corresponding symbol
also appears: .
SETTING THE TIME
For correct management of the water filtering and use of the
energy savings mode, the current time must be set.
Press the “Clock” key for about 5 seconds. The current
time will be displayed, the hour digit will flash, and the respec-
tive symbol will appear on the display.
Use the keys “Up” and/or “Down” to set the hour.
Hold the keys down for rapid change.
Then press the “Clock” key to set the minutes, which
will start flashing.
Proceed as described previously.
Press the “Clock” key again to memorize the set values
and exit programming mode.
NOTES
- If no key is pressed for 5 seconds, y ou will exit the proce-
dure and any settings will not be memorized.
- There is a back-up battery that keeps the time up-to-date even
when the system is powered off.
Displaying the time
To display the time, press the “Clock” key .
ADJUSTMENT OF WATER TEMPERATURE
The water is heated by a tubular electrical heater. Do not set
excessively high water temperature, i.e. over the limit of 40°C.
The recommended temperature is 35-36°C.
PLEASENOTE!
The heater is de-activated if the pumps and/or blower are ac-
tivated and the maximum permitted consumption is exceed
(the symbol will flash on the display). In this case, if y ou
need to heat the water, the system will activate the heater 5
minutes after consumption has decreased enough to allow it
to be switched on.
To Next Page
Loading...
Need help?
General