2
Attention New Swim Spa Owner!
Congratulations on the purchase of your new Jacuzzi™ swim spa! The following is a list of
automated functions performed by your swim spa. These functions are listed below in an at-
tempt to suppress any operational concerns you may have during the rst 24 hours of own-
ership! Also listed below are important maintenance recommendations you should observe
on a regular basis to protect your new investment.
Maintain Healthy Swim Spa Water
Always maintain your swim spa’s water chemistry within the following parameters:
With CLEARRAY® Without CLEARRAY®
pH 7.4—7.6 7.4—7.6
Free chlorine No less than 1.0 ppm 3.0—4.0 ppm
Free bromine No less than 2.0 ppm 2.0—4.0 ppm
Total Alkalinity 100—150 ppm 100—150 ppm
Calcium Hardness 150—250 ppm 150—250 ppm
IMPORTANT: CLEARRAY® Water Purication System is factory installed. If the CLEARRAY®
system is altered or is not operating eciently then follow the “without CLEARRAY® water
chemistry parameters as dened by the Association of Pool and Spa Professionals. CLEAR-
RAY® requires an annual bulb replacement to properly sanitize your water.
TO DECREASE RISK OF INFECTION OR DISEASE! Always maintain your spa
lter as outlined below to ensure healthy spa water.
Required Filter Maintenance
Your new swim spa is equipped with an advanced water ltration system that provides
unsurpassed water quality! To ensure maximum water quality at all times, you should clean
the skimming lter cartridge every 3 months, or as necessary.
Required Water Replacement
You should replace the swim spa’s water every 3 months. The frequency depends on a num-
ber of variables including frequency of use, number of users and attention paid to water
quality maintenance. You will know it is time for a change when you cannot control sudsing
and/or you can no longer get the normal feel or sparkle to the water, even though the key
water balance measurements are within the proper parameters.
© Jacuzzi Hot Tubs, Inc. All Rights Reserved
To Next Page
Loading...
Need help?
General