20
11. Turn o power to the swim spa at the circuit breaker, then drain the swim spa as out-
lined in Section 13.2.
12. Rell the swim spa with clean tap water from the garden hose until water covers all
jets but does not touch the bottom of the lowest headrest with all headrests in their
lowest position (DO NOT OVERFILL!)
13. Consult your authorized Jacuzzi dealer for chemical recommendations, then add
chemicals to swim spa water to achieve a constant sanitizer reading within the levels
recommended on the inside cover of this manual.
14. Turn on jet pumps when adding chemicals to ensure proper mixing and leave your
swim spa cover open until the sanitizer level becomes stable to protect pillows and
plastic knobs from chemical attack. Refer to the inside cover of this manual.
CAUTION: TO DECREASE BUILD UP ON COMPONENTS AND MINIMIZE ACRYLIC DAMAGE!
Never ll with water from a water softener. If your water is extremely “hard”, it is
preferable to ll half way with hard water and the rest of the way with softened
water. Water that is too soft can be corrosive to metal components.
WARNING: RISK OF PERSONAL INJURY!
• To decrease the risk of injury, drowning or entrapment, never leave your swim spa
unattended for any reason while the cover is open and accessible, especially to
small children and animals.
• To decrease the possibility of contracting a waterborne illness (e.g. an infection,
bacteria or virus) and/or respiratory ailments, maintain water chemistry within step
6 parameters. If you or other bathers experience such a condition, discontinue use
and seek medical attention.
To Next Page
Loading...
Need help?
General