JWI-700C 9
= There will be a warning sound when the material quantity is less than the lower limit, and
the weight of the material is more than 20 divisions.
= No sound alarm.
8) Press numeric key 8 to set whether to save the
upper & lower limit of quantity checking.
. = Previously set quantity checking values are not retained when the unit is turned on.
. = Previously set quantity checking values are retained when the unit is turned on.
9) Press numeric key 9 to set print modes .Options are
Prt.Pr, Prt.Co and Prt.St. If Prt.Co is chosen as the print
mode, PC will be automatically selected as the
external devices.
. = manual print
. = continuous print
. = Stable printing (the weight of the weighted articles should be more than 9 divisions.
Weighted articles should be removed and the scale goes back to zero before print out the
next record.)
10) Press key MC/CK to select external devices.
Options are PC，AX，TP，Godex ,SH，
ET，TDP and ZEBRA.
11) Press Key MR to switch On or OFF RTC
function.
12) When setting is completed, press key ZERO to save and return to weighing mode.
6. Calibration Mode
1) If good linearity of the load cell was not guaranteed, linear calibration is required. After the
linear calibration is made, there is no need to make single point calibration.
2) If there is limit in weights, single point calibration is needed .it would be more accurate to
calibrate the scale with 1/3 or more of the full load.
3) Here we take 75kg weighing capacity as an example.
To Next Page
Loading...
Need help?
General
