Operation
Seat Belt
38 9821/6100-4 38
Seat Belt
General
WARNING Operating the machine without a seat belt can be dangerous. Before starting the engine, make
sure your seat belt is fastened. Check the tightness and condition of the seat belt securing bolts regularly.
WARNING When a seat belt is installed on your machine replace it with a new one if it is damaged, if the
fabric is worn, or if the machine has been in an accident.
Inertia Reel Seat Belt
Fasten the Seat Belt
WARNING If you do not wear your seat belt you could be thrown about inside the machine, or thrown out of
the machine and crushed. You must wear a seat belt when using the machine. Fasten the seat belt before
starting the engine.
1. Sit correctly in the seat.
2. Pull the seat belt and the tongue from the inertia reel holder in one continuous movement.
3. Push the tongue into the latch. Make sure the seat belt worn is snug and properly located on the body.
Make sure the seat belt is not twisted and that it is over your hips not your stomach.
3.1. If the seat belt 'locks' before the tongue is engaged, let the seat belt retract into the inertia reel holder
then try again. The inertia mechanism can lock if you pull the seat belt too quickly or if the machine
is parked on an slope.
Figure 24.
A Tongue B Latch
WARNING! If the seat belt does not 'lock' when you check if the seat belt is operating correctly, do not drive
the machine. Get the seat belt repaired or replaced immediately.
4. To make sure the seat belt operates correctly, hold the middle of the seat belt and pull quickly. The seat
belt should 'lock'. Refer to Figure 25.
To Next Page
Loading...
Need help?
General
