Maintenance
Tracks
143 9821/6100-4 143
Tracks
General
Clean
1. Make the machine safe.
Refer to: Maintenance Position (Excavator Arm Lowered) (Page 122).
2. Park the machine on solid, level ground.
3. Lower the bucket to the ground.
4. Clean the tracks with water.
5. Track forwards or backwards to clean the remainder of the tracks.
6. Make the machine safe.
7. Examine the track, roller sprockets and idler wheels for damage or oil leaks. Replace any damaged parts.
If in doubt consult your JCB distributor.
Steel
Check (Operation)
WARNING Recoil unit servicing must only be carried out by JCB dealers. You could be killed or injured if
you tamper with it.
Notice: Always make sure that the track tension measurement is not less than specified or severe strain
to the track will result.
Check the Tension
WARNING A raised and badly supported machine can fall on you. Position the machine on a firm, level
surface before raising one end. Ensure the other end is securely chocked. Do not rely solely on the machine
hydraulics or jacks to support the machine when working under it. Disconnect the battery, to prevent the
engine being started while you are beneath the machine.
1. Park the machine on solid, level ground.
2. Operate the tracks backwards and forwards several times.
3. Stop the machine after operating the tracks forwards.
4. Set the machine in the posture shown with the track to be checked raised from the ground and supported.
Add a support under the machine.
To Next Page
Loading...
Need help?
General
