Operation
Starting the Engine
44 9821/6100-4 44
Unique Key Immobiliser System
Introduction
Each machine is supplied with a master key (red) and two ignition keys (black). The master key is used by the
operator to program the ignition keys. You must use an ignition key to start or operate the machine.
Figure 31.
To Disarm the Immobiliser
1. Put the ignition key in the ignition switch.
2. Start the engine.
Figure 32.
A LED (The position may vary).
To Arm the Immobiliser
1. Stop the engine. Remove the ignition key.
2. The immobiliser immediately arms automatically.
To Add a New or Additional Ignition Key
The ignition keys can be programmed to start more than one machine.
1. Put the master key in the ignition switch.
2. Turn the master key to position 1. The LED will flash three times.
3. Turn the master key to position 0. Remove the master key.
4. Put a new or an additional ignition key in the ignition switch. Turn the ignition key to position 1. The LED
will flash four times.
5. The new key has been added.
To Remove the Program From an Ignition Keys
The ignition keys can still be used on any other machine on which they have been programmed.
1. Put the master key in the ignition switch.
To Next Page
Loading...
Need help?
General
