Maintenance
Safety Equipment
95 9831/7750-1 95
Safety Equipment
Check (Operation)
Neutral Start
1. Enter into the machine.
2. Wear the seat belt.
3. Put the drive lever in park brake position and start the engine. If the engine fail to start, contact your local
JCB dealer to rectify the faults.
4. Put the drive lever in forward or reverse position and start the engine. If the engine start, contact your local
JCB dealer to rectify the faults.
Operator Seat Switch
1. Enter into the machine.
2. Sit on the operator seat.
3. Put the drive lever in park brake and start the engine.
4. Operator seat switch icon on the instrument panel should be extinguished.
5. If the operator seat switch still illuminate, contact your local JCB dealer to rectify the faults.
6. If the drive lever is not in park brake position and operator seat is not occupied then the engine will cut
off with in specified time.
Duration: 2 s
Emergency Stop Button
Press the emergency stop switch on the steering column and the engine will be stopped. If any controls are
still functional, contact your local JCB dealer to rectify the faults immediately. Do not use the machine until
the fault is rectified.
To Next Page
Loading...
Need help?
General
