C
C
D
D
C
C
D
D
C
C
C
C
D
D
Case 1 : Longer C and shorter D
Adjustment : [P26] Decrease the set value.
C becomes shorter and D becomes longer.
Case 2 : Shorter C and normal D
Adjustment : [P26] Increase the set value.
C becomes longer and D becomes shorter.
Case 3 : C is longer.
Adjustment : [P77] Change the set value to such a value that
shortens C.
Case 4 : C is short.
Adjustment : [P77] Increase the set value.
C becomes longer.
Case 5 : Normal C and longer D
Adjustment : [P25] Decrease the set value.
C becomes longer and D becomes shorter.
Case 6 : Normal C and shorter D
Adjustment : [P25] Increase the set value.
C becomes shorter and D becomes longer.
Start point
Start point
Start point
Start point
Start point
Start point
How to balance stitches for [End Back-Tacking] (Function setting Nos. P25, P27 and P77)
Example) Step 1: Setting stitch number for End Back-Tacking C and D = 3
Step 2: Sewing the pattern in normal speed.
Step 3: If unbalanced situation is appeared please correct it as below:
Suggestion: Select the balance stitches for Section C before selecting for D.
– 39 –
To Next Page
Loading...
Need help?
General
