JUKI DDL-8700-7 Engineer's Manual

− 63 −
Part No. : 40095287
SC-920 + M92
Drawer stopper installing
position (On the botton surface)
4 x ø3.4 on the bottom
surface, depth 20
ø18 through
hole
ø35
through hole
ø13 through
hole
2-ø3.4 on the bottom
surface, depth 10
(Drill a hole at the
time of set-up)
Detail drawing of measure (2:1)
Y-Y
Rubber cushion installing
drawing for reference
C1.5 to C2.5 (For hinge side only)
Type: Helvetica Reg Condensed
Condensed voided letters
Thickness 1.5
Thickness 0.8
Thickness 0.5
Thickness 1.5
(To be machined from
the bottom surfce)
ø16 depth 30
2-ø3.5 depth 10
2 - ø3.5 depth 4
2 - ø3.5 depth 10
2 - ø3.5 depth 4
JUKI logo type
X–X
Rubber cushion installing
drawing for reference
8. DRAWING OF THE TABLE

– 64 –
2 x ø3.4 on the bottom surface, depth 20

JUKI DDL-8700-7 Specifications

General

Max Stitch Length	5 mm
Needle Bar Stroke	30.7 mm
Lift of the Presser Foot	By hand: 5.5 mm, By knee: 13 mm
Lubrication	Automatic
Needle	DB×1
Hook	Full rotary hook
Power Requirement	Single-phase 100~120V, 200~240V
Motor	Direct-drive servo motor
Weight	45 kg