113
11–1. Error code list (Error display in panel)
There are the following error codes in this device. These error codes interlock (or limit function) and inform the
problem so that the problem is not enlarged when any problem is discovered. When you request our service,
please confirm the error codes.
No.
Description of error detected
UP position detection error when turn-
ing ON the power
Smart media cover open
Disconnection of synchronizer connector
Synchronizer lower position sensor failure
Synchronizer upper position sensor failure
Overload of motor
Machine head connector failure
Smart media not inserted
Read error
Write error
Write protect
Format error
External media capacity over
File size over
Pattern data size over
File compatibility error
Travel limit over
Operation error
Fall detection switch failure
Pattern setting error of continuous
stitching and cycle stitching
Cycle stitching pattern error
• When needle position is not UP position at the time
of turning ON the power.
• Lid of smart media slot is open.
• When position detection signal is not inputted from
the sewing machine head synchronizer.
• When the synchronizer has broken.
• When the machine head is locked.
• When sewing extra-heavy material beyond the
guarantee of the machine head.
• When the motor does not run.
•
When the machine head connector is not properly read.
• Smart media is not inserted.
• Data read from smart media is not possible.
• Data write to smart media is not possible.
• Smart media is in write prohibition state.
• Formatting cannot be performed.
• Media capacity of smart media is short.
• File is too big.
• Number of stitches and data amount which can be
handled with device are over.
• There is no file compatibility.
• Sewing data has exceeded sewing possible area.
• Operation of sewing data cannot be performed.
• When fall detection switch is inputted in the state
that the power is turned ON.
•
When pattern No. is not set to continuous stitching.
•
When the number of stitches of 1st step of continuous stitching is "0".
• When pattern No. is not set to cycle stitching.
• When pattern to be used in cycle stitching becomes
error.
−
−
003
004
005
007
008
011
012
013
014
015
016
019
024
032
040
042
302
490
491
−
−
−
−
−
−
−
−
−
−
−
−
−
−
−
−
−
7 times flash
7 times flash
Cause
Item to be checked or corrective measure
Mirror LED flash
Pictograph display
• Set to UP position by turning handwheel by
hand.
• Connect synchronizer connector.
• Close the lid.
• Check the synchronizer connector (CN30) for
loose connection and disconnection.
• Check whether the synchronizer cord has
broken since the cord is caught in the machine
head or the like.
• Check whether the thread has been entangled
in the motor pulley.
• Check the motor output connector (4P) for loose
connection and disconnection.
• Check the machine head connector (CN54) for
loose connection and disconnection.
•Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Turn OFF the power.
• Check whether the machine head is tilted
without turning OFF the power switch (sewing
machine operation is prohibited for safety sake).
•
Check whether the fall detection switch cord is caught
in the sewing machine or the like and has broken.
• Check whether the fall detection switch lever is
caught in something.
• Re-enter data after reset operation.
• Set pattern No. and number of stitches.
• Re-enter data after reset operation.
• Correct data of pattern which becomes error.
To Next Page
Loading...
Need help?
General
