iii
CAUTION BEFORE OPERATION
• Remove the air-vent cap (red color) attached to the sewing machine bed.
• Be sure to fill the oil tank with oil before use.
• Remove the needle bar stopper.
• Clean the sewing machine thoroughly before using it for the first time.
• Remove all dust collected on the sewing machine during the transportation.
• Confirm that the voltage and phase are correct.
• Confirm that the power plug is properly connected.
• Never use the sewing machine in the state where the voltage type is different from the designated one.
• The direction of rotation of the sewing machine is counterclockwise as observed from the handwheel side.
Be careful not to rotate it in reverse direction.
• Do not tilt the machine head toward this side since oil leakage or parts breakage occurs.
•A safety switch is installed so that the sewing machine cannot be operated with the machine head tilted.
When operating the sewing machine, turn ON the power switch after properly setting the head on the table.
• Before starting a test run, remove the bobbin case and the needle thread from the machine.
• For the first month after set-up, use the machine at a reduced sewing speed of 3,000 rpm or less.
• Operate the handwheel after the sewing machine has totally stopped.
WARNING :
To avoid malfunction and damage of the machine, confirm the following.
To Next Page
Loading...
Need help?
General
